uc捕鱼大闹天宫3

Shandong China Transport Logistics Equipment Group
Shandong China Transport Logistics Equipment Group

Good China Registered Mark China Transport zhufeng zhuitao zhuiyun dazhongyun

uc捕鱼大闹天宫3 +86-537-2350961

sales@chinacoalintl.com

News Detail

How To Effectively Use Plug Type Sliding Buffer Stopper

Summary: As is known to all, plug type buffer stopper is installed at the end of the railway line to prevent vehicles from sliding into the buffer stopper equipment. Plug type buffer stopper how to effectively use the plug type sliding buffer stopper, it is necessary to pay attention to its installation method. I hope this article can provide some guidance and help to the majority of buyers.

uc捕鱼大闹天宫3 As is known to all, plug type buffer stopper is installed at the end of the railway line to prevent vehicles from sliding into the buffer stopper equipment. Plug type buffer stopper how to effectively use the plug type sliding buffer stopper, it is necessary to pay attention to its installation method. I hope this article can provide some guidance and help to the majority of buyers.

 

uc捕鱼大闹天宫3 First, the installer shall place the left and right arms on the basic rail, and then connect them with the support with the pin shaft of the arms.

 

Second, then raise the supporting arm and place the spring seat, plate spring and bearing seat in sequence on the basic rail below the hoof block.

 

uc捕鱼大闹天宫3 Three, at this time to use the brake rail shoe block clamping, also clamping the basic rail rail head, and then with three bolts will brake rail belt. It is important to note that the two outer bolts should pass through the support frame and the bearing seat should be located in the middle of the pressure hole.

 

Four, plug type buffer stopper with the front, rear beam and up, down oblique beam two arms four feet connected, the middle of the two oblique beam and four corners with the pin shaft belt. After finishing the above initial installation, tighten the bolts in each part.

 

Five, the installation step of the booster is to place the spring seat, plate spring and bearing seat on the basic rail in turn, and then use the two booster brake rail to clamp it in the middle, and also clamp the rail head of the basic rail, and then tighten the brake rail with two bolts. One pair of booster is 100mm away from the main frame, and the other pair is 80mm away from the main frame, parallel to each other, and the error is no more than 2mm.

 

uc捕鱼大闹天宫3 Six, buffer is used for plug type pressurizer to each spring plate pressure: insert the u-shaped pressure fast socket on both sides of the neutral, installed in the center of the pressurizer nut compression screw rod head alignment pressurized, hung on the bottom hook in the basic pressure on both sides of the rail track on the floor, with a nut and tighten, with about 1.5 m long iron screw dynamic compression screw and the wedge between iron into the socket and plate spring, plate spring and the spring seat clearance was 0.6 + / - 0.05 mm.

 

uc捕鱼大闹天宫3 Install the sign board on the support.

 

Note: after each installation, position marks should be painted on the rail waist to facilitate daily inspection of whether the train block is damaged.

 

Above is the installation step of plug type buffer stopper, you should remember, every step is very important. How to effectively use the plug type buffer stopper , we will see whether the correct maintenance and installation. If you also want to learn more about the car block content, welcome to buy!