How To Make The Working Process Of Backhoe Loaders Safe
Backhoe loader is a single unit consisting of three construction equipment. Commonly known as "busy at both ends". During construction, the operator only needs to turn the seat once to change the working end. The main work of the backhoe loader is to dig trenches to lay pipes and underground cables, lay the foundation for the building and establish a drainage system. The device is simple to operate and highly efficient and is becoming increasingly popular. But because of improper operation also caused many safety accidents, how to make the working process of the backhoe loader safe? We have summarized 9 safety precautions after starting the engine and when the backhoe loader is working:
uc捕鱼大闹天宫3 1 After the engine starts, it is ready to start after the brake pressure reaches a safe pressure to ensure driving safety during braking. Press the bottom of the emergency brake (if equipped) and the parking brake button (this button can only be pressed when the pressure reaches atmospheric pressure, otherwise it will jump automatically when pressed), release the emergency and parking brake until I start Hanging blocks. If there is no emergency brake, simply lower the parking brake lever and start it after releasing the parking brake.
2 On the sidewalk of the backhoe loader, obvious failures are very important. Pay special attention to iron, obstacles such as ditches to avoid cutting the tire.
3 Adjust the rearview mirror for the best visual effect.
4 Make sure that the horn, backlight and all safety devices of the backhoe loader are working properly.
uc捕鱼大闹天宫3 5 Before starting or checking the turning direction, you should honk to warn the people around you.
uc捕鱼大闹天宫3 6 Before you start walking, you should handle all the joysticks, pedals, and steering wheels and try again. Make sure you are in a normal state and start working. Before starting operation, please pay special attention to check the steering and the brakes are intact.
7 While walking, place the bucket about 400mm from the ground. When working on slopes in mountainous areas or through obstacles such as ditches, slow down the speed and keep the corners small to avoid tipping. When the loading surface begins to slide on the steep side, it must be unloaded immediately to prevent further sliding.
8 There are too many holes and they are too slippery. Try to avoid dangling wheels. When two tires are on the ground, it is forbidden to continue walking.
uc捕鱼大闹天宫3 9 When using and tractors, only tow hooks are allowed, and people are not allowed to stay between the load and the backhoe loader, and maintain a safe distance to prevent accidents.
Safety is no small matter. When using backhoe loaders, we must pay attention to the above points to prevent problems before they occur! !!